Install GSP32
A MicroPython web UI for ESP32 and ESP32-S3 boards. Plug your board in with a USB data cable and install it right from this page; it picks the right firmware for your chip.
Use Chrome or Edge on a Desktop Computer
This page talks to the board over a USB cable. Phones, tablets, Firefox, and Safari cannot do that. Open this page in Google Chrome or Microsoft Edge on a desktop computer.
- 1. Plug In Your Board
- 2. Click Get Started
- 3. Install or Set Up Wi-Fi
Works in Chrome or Edge on a computer.
Don't See Your Board?
- Use a Data Cable. Some USB cables only charge. Try another cable you know carries data.
- Try Another Port. Plug the board straight into the computer instead of a hub or dock.
- Install the USB Driver. Look at the small chip next to the board's USB port: "CP2102" or "CP2104" needs the Silicon Labs CP210x Driver; "CH340" or "CH341" needs the WCH CH340 Driver.
- Hold BOOT While Plugging In. Hold the board's BOOT button, plug the cable in, then let go.
- Try Again. Click Get Started and pick the board's port.
ESP32 Board
Checking for GSP32…
Changing Tabs Could Cause the Install to Fail
This Board Is Not Supported
Install GSP32
Installs Loading...
Installing GSP32
Connecting to the board...
Set Up Wi-Fi
Waiting for the board to start...
Something Went Wrong
- The console below shows what happened. Click Copy Log to share it.
- Unplug the board, plug it back in, and try again.
- Close Arduino, Thonny, mpremote, and other programs that use the port.